5 Useful Tips for Water Heater Repair

Whether you have an electric or gas water heater, they need repair after some years of wear and tear. It is always likely that if you are planning to make a replacement, then you would do with the same kind of water heater as you would have already got comfortable using and maintaining it for years, unless you are really not happy with the water heater quality and expenses incurred in maintaining it. Besides this, you would have already set the heater some dedicated space in your home by constructing some kind of mantle space for it, so people tend to use a similar kind of water heater every time you replace. This article speaks in general about the tips you must take care of your water heater repair.

Below are some of the tips for water heater repair.

1. Increase efficiency

Seattle plumbers help in not only repairing but also increasing your water heater efficiency. This will increase the longevity of your water heater. Adding insulation, setting temperature, flushing tank, validating anode rod, etc need to be done every year. Heat costs can be reduced up to 45% if you add insulation and save 9% off water heating costs as quoted by the handyman services. Make sure that you regularly check the anode rod to prevent your heater from corroding and reducing its shelf life.

2. Check the TPR valve

When Seattle plumbers being their repair work, they usually shut off the power as well as the valve which supplies cold water. Next, place a water holder or a bucket beneath the pipe connected to the TPR (temperature pressure release) valve which may be located on top or beside the tank. If the tank pressure gets high the valve usually opens up. Lift the valve’s tab to remove some water and if it starts overflowing, drain the tank a little bit and unscrew the old valve with a wrench and install new one.

3. Check the anode rod

Emergency plumbers in Seattle can help to fix the anode rod in case you start seeing the corrosion in your water heater. Quick action needs to be taken in order to increase the shelf life of your water heater. They usually put a hose to the drain cock of the tank and allow some water to flow out. Later they fit the socket into the rod’s head and unscrew it.

4. Drain the tank and clean the sediment on a regular basis

water heater repairs

This is the first task any plumber in Seattle would do when you call them for maintenance and water heater repair work. They usually drain the left out water in the bucket and stir the sediment. Cold water supply valve is opened and repeatedly drained until the tank is clean and all the sediment is washed out. After the cleaning is complete, the valve is closed and the tank is refilled with fresh water and power is turned on.more useful tips at http://www.houselogic.com/home-advice/water-heaters/water-heater-energy-saving-tips/#.

5. Take care of hissing and sizzling noises

Handymen services make sure that the water heater doesn’t leak at any point of time and might even replace the valve if needed. To repair any leakages, fittings can be tightened and if it doesn’t work, valves can be shut off and fittings can be replaced.

Related Posts:

Leave a Reply

Your email address will not be published. Required fields are marked *