How to Tell If You Need a Water Heater Repair

In order to understand when exactly is the right time for your water heater repair, you must consult Seattle plumbers who are pretty much experienced and can tell you when exactly your heater needs to undergo maintenance work. Gas and electric water heaters are the 2 main types available in the market. Electric water heaters can be used anywhere while a gas water heater is usually installed at home. It is likely that if you are planning to replace the water heater, then you would want to replace a similar one as the previous.

Plumber recommendations

Plumbers in Seattle recommend to regularly keep checking your water heater’s anode rods before it completely corrodes the water heater surface. Water heater repairs are needed at regular intervals when the heaters are around 8 to 10 years old. The base starts leaking after a couple of years of wear and tear and hence the parts need to be replaced. When there is a unit failure, it is not just the electrical problem such as blown fuse or the breaker which is the root cause of the problem. A Seattle plumber can fix all these issues for the cost of $150 to $300.go straight to http://structuredfoundationrepairshouston.com/ for more water heater repairs.

Detect the common problems

You must be aware of what are the common problems before we get to know when is the time to go for a water heater repair. Most common problem could be when people start complaining that their water isn’t hot enough. Make sure you do the below steps to check and see if your water is hot enough for an electric water heater.

• Ensure the power cable is connected
• Remove the sediment by flushing the heater
• You need to insulate the hot water pipes
• Heating element or the thermostat should be replaced
• The thermostat’s temperature setting should be raised

Besides this, if you have a gas water heater, then

• Insulate the water pipes
• Gas burners need to be checked
• Sediment should be removed from the tank by flushing the heat

Sometimes there may be sizzling noise when sediment gets collected beneath the water tank. In order to take care of this, the tank needs to be drained until water gets cleared. Handyman services are good in detecting water pipes might start leaking and there might be leakages in the pressure-relief valve as well.

Water Heater Repair

Below are some tips that can help you decide on troubleshooting yourself and figuring out the right time for repair.

• If there is an electric trip in the circuit breaker
• Heating element or burner fails
• Valve sticks
• Thermostat breaks
• When there is a flicker in the Pilot light of a gas heater
• There might be faulty plumbing installations which lead to mixing of cold and hot water.
• Faulty thermostat caused by faulty electric connections can cause severe damage to the water heater.
• Heating unit thermostat setting is too high, check this out!

Related Posts:

  • No Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *